[rwhite]

Just purchased a Stealth Switch AT-5 for my photo booth. Quick question, does it use mono or stereo 3.5mm headphone cables? I am guessing mono but want to make sure.
Also is there certain specs on the arcade buttons I need to be aware of. I just did a search on arcade buttons and most of them say 12v.

Thanks for any help folks.

Bob

[CheekyPix]

Im using the AT-5.. they take standard mono jack plugs

[Chris Breeze]

Just purchased a Stealth Switch AT-5 for my photo booth. Quick question, does it use mono or stereo 3.5mm headphone cables? I am guessing mono but want to make sure.
Also is there certain specs on the arcade buttons I need to be aware of. I just did a search on arcade buttons and most of them say 12v.

Thanks for any help folks.

Bob

Arcade buttons are basically just press to make switches (i.e. press the button to complete the circuit) and are typically rated up to 12 volts. This is fine for connecting to a StealthSwitch.

[rwhite]

So will these buttons work with the Stealth Switch AT-5?
Will they be illuminated?

http://www.allelectronics.com/make-a-store/category/716/Switches-Pushbutton/1.html
Looking at the 12V LIGHTED PUSHBUTTON, 2" RED LENS type switches


Bob

[Chris Breeze]

They should be fine. You need a separate power supply to illuminate the buttons.

You might find this article useful if you want to be able to turn the lights on and off:
http://www.breezesys.com/articles/photobooth_lights.htm